Final Year Project Logbook

Activity:  Replace Air Tube Compressor Objective: To fix the broken air tube compressor To found out causes of the problem happen Content: The current air tube compressor between air compressor to rotating cylinder was ruptured due to high air pressure as well as the old condition of the tube. It cant fix by cover it with tape because the pressure of the air is too high.  The size of the air tube is internal diameter 4mm and the outside diameter is 6mm The new air tube compressor was ordered from Shoppe website.  The whole air tube on the project need to change due the old condition and can risk of damage.  Result: After I change the new air tube compressor, the project was running smoothly. The air flow from air compressor in tube was run very well. Conclusion: From this situation, I need to check all the component of hardware to make sure there all in good condition to prevent problem like this in future. 

Activity: Presentation Day Briefing Objective: To brief out about Project Presentation and important deadline for FYP 1 & 2 Content: The briefing was conduct on Microsoft Team by Sir Shaiful which is my supervisor and FYP coordinator  The important criteria that must be on the slide presentation is problem statement, methodology, project flow and result  Sir Shaiful also informed regarding the task that needs to be done by student which is technical report and the date to be delivered Furthermore, he also mention about project money claims Result: From the briefing, the important point that I get is student need to submit draft of technical paper and project report to supervisor by week 16. The demonstration of project video also need to upload by week 16 and the lastly the presentation day is conduct on week 17. Conclusion: I can be more prepared and need to finish the project work early so that I can record for the demonstration. The student also encourage...

Activity: Replace the Arduino Board (ESP8266) Objective: To replace the damaged original Arduino board. To check the wiring connection between NodeMCU, sensors and relay. Content: The original NodeMCU board suddenly getting hot and the light on the board become turn off At first I expected that what was broken was the cable. So i try change and replace the cable but the result is still same. The NodeMCU board not function. I try to troubleshoot the board and connect with other laptop but still not function. After i make a research, the NodeMCU board was short circuit and overload current. So the solution is i need to change with the new one. Result: So I change the new board, upload the coding from the Arduino software after done upload the coding, i connect all the sensor and relay As a result, the arduino and other sensor was functioning well. Conclusion: The cause of this problem is  the VCC/GND are internally connected due to a previous failure or  An output...