Week 6 (FYP 1)

-
Activity: 
Make a research on the new sensor which is current sensor

Objective:
  • To understand more detail about how current sensor work 
  • To figure out that current sensor is suitable to use in this project
Content: 
  • make some research  about the connection between current sensor and any loads
  • make a research to know the circuit diagram and Arduino coding to programmed the sensor
Result:
  • The information that i get from the research, the current sensor ACS712 can use at any load DC or AC.  The input  voltage is +5V for typical applications
ACS712 Current Sensor

  • Sensor Specifications:
    • Measures both AC and DC current
    • Provides isolation from the load
    • Easy to integrate with MCU, since it outputs analog voltage
  • Circuit Diagram for the sensor and load

Conclusion:
Based on the information, the current sensor is quite easy to install in the stamping machine. Nevertheless, I need to discuss with Sir Shaiful whether he agrees or he has other additional ideas on this project.



Comments

Post a Comment

Popular posts from this blog

Week 11 (FYP 1)

-
Image
Activity: Design a Presentation Slide and Discussion with Supervisor Objective: to make a good presentation slide to prepare for the presentation in the 12th week to seek views and advice from supervisors Content: Make a presentation slide based on the FYP criteria set by the coordinator. The slide contains Introduction, Problem Statement, Literature Review, Methodology and Result. The section to be concerned about is a summary of the Literature Review After completing the slide, I met and discussed with Sir Shaiful to review the slide and give advice on the presentation later Result: After Sir Shaiful reviewed the slide, it gave an overview of the Flowchart section and Estimated costs on the project. Sir Shaiful also gave some advice during the presentation later. Conclusion: After being satisfied with the slide, I can proceed to the next task which is to record the presentation video to be played on the presentation day next week. The presentation will take place online at Micros...
Read more

Week 15 (FYP 2)

-
Image
Activity: Recording project demonstration. Objective: To produce a good and clear demonstration video. To produce a project demonstration video that can be understood by the evaluator. Content: Choose a suitable and quiet place to record a demonstration video. Make drafts and plans to record video. Choose the suitable angle for place of camera. Run the project and start recording. Result: The suitable place is chosen which in store room at groundfloor. The demonstration video was recorded with several different angles as there were several important parts running at one time such as the temperature sensor and the IR sensor. I need to add background voice of explanation because during recording, I cant make explanation because the sound of compressor is too loud. Conclusion: As a conclusion, successfully created video demonstration for online presentation which will attract the attention.
Read more

Introduction

-
  My name is Mohd Ikmal Shahrizal b Ab Razak. I am a student in UNIVERSITI KUALA LUMPUR BRITISH MALAYSIAN INSTITUTE (UNIKL BMI). My course is BACHELOR of ENGINEERING TECHNOLOGY (HONS) in ELECTRICAL. Basically, this blog is about my logbook or my progress report on my FINAL YEAR PROJECT that I've made will updated in this blog.  My project title is Development of  IoT System for Automation System
Read more